SMPS by SIEMENS

POWER SUPPLY-SITOP PSU8200/1AC/24VDC/5A-6EP33338SB000AY0

DATA SHEET
In stock

Description

POWER SUPPLY-SITOP PSU8200/1AC/24VDC/5A-6EP33338SB000AY0

SITOP PSU8200 24 V/5 A stabilized power supply input: 120/230 V AC output: 24 V DC/5 A

INPUT type of the power supply network 1-phase AC

supply voltage at AC Automatic range selection

supply voltage 120 V/230 V

input voltage 1 at AC 85 ... 132 V

input voltage 2 at AC 170 ... 264 V

wide range input No

buffering time for rated value of the output current in the event of power failure minimum 35 ms

operating condition of the mains buffering at Vin = 120/230 V

line frequency 50/60 Hz

line frequency 47 ... 63 Hz

input current

● at rated input voltage 120 V 2.1 A

● at rated input voltage 230 V 1.2 A

current limitation of inrush current at 25 °C maximum 10 A

I2t value maximum 0.2 A²·s

fuse protection type T 3.15 A (not accessible)

fuse protection type in the feeder Recommended miniature circuit breaker at 1-phase operation: from 6 A (10 A) characteristic C (B); required at 2-phase operation: circuit breaker 2-pole connected or circuit breaker 3RV2011-1EA10 (setting 3.8 A) or 3RV2711-1ED10 (UL 489) at 230 V; 3RV2011-1DA10 (setting 3 A) or 3RV2711-1DD10 (UL 489) at 400/500 V

output

voltage curve at output Controlled, isolated DC voltage

output voltage at DC rated value 24 V

output voltage

● at output 1 at DC rated value 24 V

output voltage adjustable Yes; via potentiometer

adjustable output voltage 24 ... 28.8 V; max. 120 W

relative overall tolerance of the voltage 3 %

relative control precision of the output voltage

● on slow fluctuation of input voltage 0.1 %

● on slow fluctuation of ohm loading 0.2 %

residual ripple

● maximum 50 mV

voltage peak

● maximum 200 mV

display version for normal operation Green LED for 24 V OK

type of signal at output Relay contact (NO contact, rating 60 V DC/ 0.3 A) for “24 V OK”

behavior of the output voltage when switching on Overshoot of Vout approx. 3 %

response delay maximum 1.5 s

voltage increase time of the output voltage

● typical 30 ms

output current

● rated value 5 A

● rated range 0 ... 5 A; As of Ua>24 V: 4% [Ia]/V [Ua]; at Ue<100 V/<200 V: 80% Ia rated

supplied active power typical 120 W

short-term overload current

● at short-circuit during operation typical 15 A

duration of overloading capability for excess current

● at short-circuit during operation 25 ms

constant overload current

● on short-circuiting during the start-up typical 6 A

bridging of equipment Yes; switchable characteristic

number of parallel-switched equipment resources for increasing the power 2